This Won't Do.
The hottest day of the year so far was an excuse for The Ambassador's Daughter and me to try out another beach cafe, this time at Winterton-on-Sea.
The sun shone, the roads were practically empty and the Hillman (with a new 40 zillion volt coil) ran like a dog for most of the 130 miles there and back. The snag was that after a longish run at a steady speed, the slowing down for a roundabout or somesuch, caused the engine to miss and cough and splutter on the exit and continue to misbehave for the next couple of miles until the (indicated) temperature came down a couple of degrees again. Even then there was no guarantee of consistent running until I strapped the bonnet open with the help of my trousers belt and a bungee cord that I found in the tool bag. This helped to get some cooler air going past the carb and reduce the temperature under the bonnet. We just made it back to the farm where of course, the engine sat and ticked over as smooth as silk.
So it could have been a bunch of things. Air in the fuel line (there were some bubbles in the gascolator but the carb's float bowl should eliminate any problem there) or fuel evaporation as the carb heats up with the transfer of the heat from the block when slowing down, rubbish fuel (I always buy the expensive unleaded) or a combination of all those things. It's definitely not electrical as the system is producing plenty of sparks and it runs really sweetly on tick over and low revs. When it gets hot, the problems start, though, having said that, at one point in my fury I dropped it into 3rd, pushed it up to and past (an indicated) 5000 rpm where the power band comes in and it just wanted to go, pulling like a train without a moment's hesitation.
It's enough to drive a chap nuts. More interestingly, I spotted this little sprint job at the local bike meet and wondered why I hadn't had the same idea with my first motorcycle (also a BSA C15). Krazy Horse always puts on a good show and it's very well attended. The combination of art and engineering that goes into some of the bikes on show is really inspiring.
As is Leon's Coventry Climax installation in his A7. It looks and sounds fabulous and it's only taken him about 5 minutes to complete!
And this is what I like...
... the car as an aide-memoire. That's art. I was telling Leon about my troubles with the Hillman and describing the symptoms when something he said reminded me that the air intake to the carb is not an open bell-mouth like on the Austin, but via an air cleaner which sits on the top of the engine in the hottest part of the bonnet. I wondered if I made a couple of air scoops to help pull in cool air directly into the air cleaner gauze, it might make a difference to the running?
Years ago I made up a beech tool to press out some aluminium fairings for the Jodel control cable exits.